

- Machines compliant to 2006/42/CE standard
- Bending rolls independently adjustable, for double pre-bending capability on the leading and trailing end of symmetrical profiles
- 3 driving rolls to guarantee maximum drive on the profile
- Lateral guide rolls with three-dimensional adjustment
- Standard bending rolls of alloy steel, heat treated to surface hardness 60 HRC
- Modular rolls that allow the bending of most profiles
- Free standing remote control station to control the machine in safety
- Possibility to install the machine both in vertical and horizontal position
- Torque limiter installed on top roll shaft
- One-piece fabricated steel frame
- Shaft and pinions installed on high dynamic load roller bearings
- Gears coupled directly on splined shaft
- Water based environmental friendly paint
Only the Model 315 is larger than the Serie 3000 Model 314, which covers a section modulus of 750 to 1600 cm³. It runs on a 330 mm upper shaft and a 300 mm lower shaft with 750 mm rolls, driven at 75 kW. Rolling speed is 0 to 7 m/min and the machine weighs 33,000 kg. The one-piece fabricated steel frame, roller bearings for high dynamic loads and water-based, environmentally friendly paint are the same as on the rest of the range.



